Paper Route - Manual (Top), Tractor feeder (Rear), Tractor feeder (Bottom), Cut sheet feeder (Rear), Roll paper standĬharacter Pitch - Super Speed Draft : 12.0 cpi Print Speed - Super Speed Draft : 435 cps, High Speed Draft : 387 cps, Utility : 290 cps, Near Letter Quality : 73 cps Print Direction - Bidirectional/Unidirectional printing, Short line-seeking printing Adjust the paper so the first line of print aligns with the Red Line located on the Clear Plastic Ribbon Protector.Oki Microline 320 Turbo 9 Pin Impact Printer D22800A Press FORM FEED to move the paper up or LINE FEED to move the paper down. If its set for anything other than 'OFF'(1 or 2 seconds) then it is considered 'ON'. Locate the 'FORMS TEAR OFF' setting in the printed menu and take note of its setting. Press SEL (The SEL light Should go out)ĥ. To do this you must print the menu as described below.Ģ. IF you must use it for removing paper jams be sure the power to printer is off.Ĭhecking to see if Forms Tear off is 'ON' or 'OFF'.īefore setting the Top of Form you need to verify what the Forms Tear Off is set for. Doing this will always change the TOF setting. Note2 - DO NOT TURN PLATEN KNOB ON RIGHT HAND SIDE OF PRINTER. You may need to use the instructions below to Re-adjust according to your software's needs. Note1 - Your software may be printing the first line of print above or below where TOF is set. It needs to be set when the first line of print does not print in the desired location. Top of Form(TOF) is the position on the paper where the first line of print will occur.

Oki microline 320 turbo paper size